Parent: [[WifiDocs/WirelessCardsSupported | Wifi Wireless Cards Supported]] | [[/PageDiscussion|Discuss this page]] = Summary = * Model - This is the full device model as noted on the box. * Chipset - Chipset vendor name, chipset name, vendor code, and device code. For example, if one was looking for a PCI device: {{{ lspci -vvnn | grep Network 04:00.0 Network controller [0280]: Realtek Semiconductor Co., Ltd. RTL8188CE 802.11b/g/n WiFi Adapter [10ec:8176] (rev 01) }}} It's the ''''Realtek'''', ''''RTL8188CE'''', and ''''[10ec:8176] (rev 01)''''. * Driver - For a PCI device: {{{ lspci -vvnn | grep -A 9 Network | grep Kernel Kernel driver in use: rtl8192ce }}} It's the ''''rtl8192ce''''. * Works "out of the box" * Yes - It works perfectly with no manual modifications, or degraded performance. * No - It doesn't work at all, has degraded performance, or requires manual configuration to make it work. Please add a comment to what you had to do to get it to work if this was possible, as well as a URL to an outstanding Launchpad bug report to address the issues encountered. = PCMCIA = || '''Model''' || '''Chipset''' || '''Driver''' || '''Works "out of the box"''' || '''Comments''' || '''Last Updated''' || || 5410 || ? || acx111 || No || Running Ubuntu 6.06 Dapper Drake. Detected card immediately and showed as active in Network Settings, but unable to connect to access point. Follow instructions in this thread http://www.ubuntuforums.org/showthread.php?t=75448&highlight=5410 and everything seems to work just fine! || 2007-01-13 || = USB = || '''Model''' || '''Chipset''' || '''Driver''' || '''Works "out of the box"''' || '''Comments''' || '''Last Updated''' || || USR5423 || ? || zd1211rw || Yes || Works flawless with 7.10. || 2007-12-02 || || 5420|| 0baf:0111 || ? || No || The latest ndiswrapper release source must be downloaded from [[http://sourceforge.net/projects/ndiswrapper/]] and the directions for building [[WifiDocs/Driver/Ndiswrapper]] followed while replacing ndiswrapper-1.1 with the version downloaded (i.e. latest at time of writing = ndiswrapper-1.5); everything works except the signal strength monitor, probably because it gets compiled against version 17 of the wireless extensions instead of 18; lastly, you'll probably need to install gcc3.4 using Synaptic otherwise build will fail || 2005-11-01 || || MAXg 5421|| ? || ndiswrapper || No || On Feisty, the udev rule should be: SUBSYSTEM=="usb", ATTR{idProduct}=="011b", ATTR{idVendor}=="0baf", ATTR{bConfigurationValue}="1". Value 011b depends on product (use lsusb command). Works fine with USR5421X.inf and networkmanager. || 2007-07-16 || ---- CategoryWireless