Diff for "LightScribe"


Differences between revisions 9 and 10
Revision 9 as of 2008-07-24 17:11:13
Size: 1954
Editor: localhost
Comment:
Revision 10 as of 2008-07-28 12:40:20
Size: 2420
Editor: mail
Comment:
Deletions are marked like this. Additions are marked like this.
Line 35: Line 35:
= Enable Enhanced Contrast =

Activating the higher contrast print mode will let you print higher quality labels, at the cost of a bit longer burn time.

 1. Run the Enhanced Contrast Utility for Linux
  {{{
sudo /usr/lib/lightscribe/elcu.sh}}}
 2. Enter '''1''' to turn on ''Enhanced Contrast'', or '''2''' to disable it.

This tip is documented on the [[http://www.lightscribe.com/downloadSection/pse/|LightScribe Pre-Release Software Evaluation]] page.

LightScribe support for Linux.

Introduction

LaCie has released the first software that allows burning labels on LightScribe media using LightScribe drives under Linux.

Prerequisites

  • x86 distribution of Ubuntu 6.06 LTS (Dapper) or newer

  • LightScribe-enabled DVD/CD burner

  • LightScribe media

  • Alien package, to install RPM packaged software in Ubuntu. If you don't have it installed or don't know if you do, use this command:

    • sudo apt-get install alien
  • Install old C library if you have Ubuntu 7.04 or newer:
    • sudo apt-get install libstdc++5

Installing

  1. Download the software from LaCie

    1. LightScribe Host Software for Linux:
      http://www.lacie.com/download/drivers/lightscribe-1.8.15.1-linux-2.6-intel.rpm

    2. LightScribe Labeler for Linux
      http://www.lacie.com/download/drivers/4L-1.0-r6.i586.rpm

  2. Install the packages using Alien
    • sudo alien -i lightscribe-1.8.15.1-linux-2.6-intel.rpm
      sudo alien -i 4L-1.0-r6.i586.rpm

      Note: The packages must be installed in this order!

    Additionally, newer software may be available at http://www.lightscribe.com/downloadSection/linux/index.aspx

Enable Enhanced Contrast

Activating the higher contrast print mode will let you print higher quality labels, at the cost of a bit longer burn time.

  1. Run the Enhanced Contrast Utility for Linux
    • sudo /usr/lib/lightscribe/elcu.sh
  2. Enter 1 to turn on Enhanced Contrast, or 2 to disable it.

This tip is documented on the LightScribe Pre-Release Software Evaluation page.

Links


CategoryDocumentation CategoryHardware CategoryCleanup

LightScribe (last edited 2015-08-02 15:46:40 by dynamic-adsl-78-14-103-191)